Compact pressure switch with display for oem applications 帶顯示的緊湊型壓力開關,用于oem應用
Compact pressure switch with display 帶有顯示的緊湊型壓力開關
The compact pressure sensors meet the electromagnetic compatibility to en 61326 緊湊型壓力傳感器滿足en 61 326的電磁兼容性emc要求。
The compact pressure sensors meet the electromagnetic compatibility acc . to en 61326 T緊湊型壓力傳感器滿足en 61 326的電磁兼容性emc要求。
Robustness and long - term stability during operation are the strengths of this compact pressure sensor for general industrial applications 對一般產業來說,堅固和穩定性強是此款緊湊型壓力傳感器的優勢。
The results showed that with 1 . 5wt % tih2 , the porosity was the maximal and above 35 / min average heating rate , the porosity clearly increased ; and along with the increasing of compact pressure , preservation time and heating temperature , the porosity would be enhanced 分析結果表明:當發泡劑tih _ 2含量為1 . 5wt時,獲得的樣品平均孔隙率最大。平均加熱速率達到35 min以上時,平均孔隙率增加顯著。隨著壓實力的增大、保溫時間的增加和樣品最終加熱溫度的升高,平均孔隙率均會增加。
The optimum conditions for air electrode preparation were shown as follows : active carbon which was baked for 15 min in 900 as carrier for catalyst , bond is 60mass % polytetrafluoroethylene ( ptfe ) liquor , 20 % ptfe in waterproof layer , 10mass % pore - making in waterproof layer thickness of waterproof layer 0 . 30mm , 10mass % ptfe in catalysis layer , nickel screen for current collector , compacting pressure 6mpa 確定制備空氣電極的最佳工藝條件為:催化劑載體的處理條件為在900下灼燒15min ,粘結劑為60mass % ptfe的水溶液。防水層中pefe含量為20mass % ,造孔劑含量為10mass % ,其厚度為0 . 3mm 。催化層中ptfe含量為10mass % 。